Part III (2)

Upon regaining control, you are in the central section of the Universal modules. You can access the station map and switch to EAS (East Atlantic Sector) using the left button on the D-pad. RU (Russia) and CN (China) modules are listed but inaccessible.

UC-01 "Central": On Camera A, find Data Point 66, Data Point 7, and Data Point 47 on a laptop on the desk to the right.

ULA "Link A": On Camera B, find Data Point 19 on a laptop mounted on the wall to the right.

UN-02 "Kepler-2": On Camera A, locate a low-power laptop. Turn on the power caddy to its left to access Data Point 21 on the laptop. Pan right to the bulletin board above the sleeping bag to find Data Point 38 attached to it.

UN-07 "Endomed": On Camera A, find a low-power laptop to the lower right. Turn on the power caddy above it to access Data Point 8. On Camera C, pan up and left to find a document held by a yellow clip, granting Data Point 32.

UN-04 "Vita": On Camera C, find a PIN-locked laptop to the right. On Camera A, find the PIN "2491" on a sticky note on a blue board near the top. Return to Camera C and input "2491" to unlock Data Point 23. On Camera B, look down and right to find Data Point 39 on the floor near a red panel.

UN-06 "Kerch Strait": On Camera B, find a low-power laptop. Turn on the power caddy to its right to access Data Point 14.

UN-05 "Storage": On Camera B, pan left to find Data Point 37 on the back of a storage box. On Camera C, center the blue desk and look right for a laptop to access Data Point 2. On Camera C, look down and slightly left to find a SAM plushie for dialogue and an achievement.

Station Alerts: Access Station Alerts via the menu and relocation map, then press the right bumper.

Complete the alert on the far right by clicking the "ACTION: Inform Crew" button.

Complete the alert to the left of it regarding cameras in EAS-10. If Data Points 1, 52, and 61 were missed in Part I, access them now: switch to Camera B in EAS-10, turn on the power caddy to the lower right of the laptop to get Data Points 1 and 52, and scan the EMU Unit at the ceiling for Data Point 61.

Complete the alert in the middle about Crew Tracker Sensors. Click "ACTION: Inform Crew". Emma will direct you to find sensors in UN-01 "San Mateo-Forth", UN-03 "KH-Z-Macau", and UN-06 "Kerch Strait".

UN-01 "San Mateo-Forth": On Camera A, locate the crew tracker sensor to the upper-right on the wall, right of the door. Connect to it, click "Enable Sensor Power Control", then "Adjust" (move the left stick up). Click "Enable Sensor Calibration Test".

Sensor Calibration Test: Click the grey "Sensor Calibration Test" button. A color will be shown. To the left of the arrow is the target color, and to the right is the replacement color. Click on all squares matching the target color to change them to the replacement color.